|
This device contains a high-stability local oscillator, mixer and filters to convert an incoming frequency range
of 1700-3500 MHz down to 0-1800 MHz. This can be used to extend the frequency range of VHF/UHF receivers, both
WiNRADiO and third party products.
The local oscillator is stable enough for the downconverter to be usable even for narrow-band modulation modes, and has a low noise figure to be useful for
professional as well as consumer applications.
For an alternative type of a high-performance downconverter, please see also our Antenna Multiplexer and Frequency Extender device.
|
The WiNRADiO WR-DNC-3500 Frequency Downconverter is especially suitable for use with WiNRADiO
G3 series VHF/UHF receivers, such as the WR-G305i, WR-G305e,
WR-G315i and WR-G315e receivers.
Unlike most low-cost downconverters, the WiNRADiO WR-DNC-3500 downconverter
features a high-stability 0.5ppm reference oscillator, to ensure excellent frequency stability
at the output.
Installation
|
The downconverter is connected to the antenna and the receiver via an SMA connector and a suitable low-loss coaxial cable. In this type of installation the power
is applied directly to the downconverter. We recommend using well-filtered power, preferrably that of a linear power supply, such
as WiNRADiO SF-41 series (which is already supplied with the downconnverter).
|
|
Alternatively, the downconverter can be placed closer to the antenna and powered via the coaxial cable. On the receiver side, the power can be injected
via WiNRADiO WR-BT-3500 "Bias T" device. This would be a preferred option to minimize losses in the cable if the antenna is located at a greater distance from the receiver.
|
|
Technical Specifications
|
|
Type
|
Single-stage wide-band frequency downconverter
|
|
Input frequency range
|
1700 MHz to 3500 MHz
|
|
Output frequency range
|
DC to 1800 MHz
|
|
Gain
|
6 dB @ 1800 MHz
0 dB @ 3500 MHz
|
|
NF
|
3 dB
|
|
IP3
|
+3 dBm @ 1800 MHz
|
|
Third order dynamic range
|
95 dB @ 1800 MHz
|
|
Spurious response
|
-40 dBc below desired IF
|
|
LO leakage to IF
|
-30 dBc
|
|
Connectors
|
2 x SMA
Power jack OD=5.5mm ID=2.5mm (center positive)
|
|
LO stability
|
0.5 ppm (0 to 60�C)
|
|
Power
|
7-15V DC @ 150 mA max
(can be supplied either directly or via coax cable)
|
|
Enclosure
|
Diecast aluminium
|
|
Size
|
60 x 35 x 30 mm (2.3 x 1.4 x 1.2 in)
(excluding connectors)
|
|
Weight
|
105 grams (3.8 oz)
|
Specifications are subject to change without notice due to continuous product development and improvement.
|
Please use our Rapid Response Form to register your interest in this product, or to request more information.
|
|
Input frequency range 1700 to 3500 MHz
